Check flood readiness at the health clinic in Pacoima, Los Angeles, CA (2026-07-10)

the health clinic in Pacoima, Los Angeles, CA has never had this checked by anyone here. Do a simple, honest check now, and come back on schedule so the people who use this place can see if it's improving. Standard: FEMA floodplain + EPA green infrastructure; SDG 11.5 Proof: photo + GPS + low-spot/drainage map + siting note Method (FEMA floodplain + green-infrastructure siting screen, ~45-90 min): 1. Confirm post-event conditions are safe; navigate to the site; record GPS. 2. Photograph deposited sediment / affected area. 3. Measure deposition depth at representative points. 4. If a sediment contaminant screen is in scope, run the metals field kit and record values. 5. Note debris, hazards, and the extent (sketch). 6. Enter depth, any analytes, hazard notes, GPS, photos into the proof record; sign. Equipment: GPS phone, tape/ruler for deposition depth, metals field kit (if sediment screen in scope), boots + gloves, camera Done when: Deposition depth recorded at representative points; Metals screen recorded (if in scope); Debris/hazard note + extent sketch; GPS waypoint + timestamped photos

Where

the health clinic in Pacoima, Los Angeles, CA

Pay

$84 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

photo + GPS + low-spot/drainage map + siting note

This is exactly what gets it approved. Nothing settles without it.

Level

entry

Open until

2026-10-10

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 45–90 minutes. Method of record: FEMA floodplain + green-infrastructure siting screen

Bring

• GPS phone
• tape/ruler for deposition depth
• metals field kit (if sediment screen in scope)
• boots + gloves
• camera

Steps

1. 1. Confirm post-event conditions are safe; navigate to the site; record GPS.
2. 2. Photograph deposited sediment / affected area.
3. 3. Measure deposition depth at representative points.
4. 4. If a sediment contaminant screen is in scope, run the metals field kit and record values.
5. 5. Note debris, hazards, and the extent (sketch).
6. 6. Enter depth, any analytes, hazard notes, GPS, photos into the proof record; sign.

If it does not match the plan

• Unstable ground / submerged debris / contaminated water -> document from safe footing; do not enter.
• Elevated metals in deposited sediment -> flag before any reuse; recommend lab confirm.

What counts as done

• Deposition depth recorded at representative points
• Metals screen recorded (if in scope)
• Debris/hazard note + extent sketch
• GPS waypoint + timestamped photos

Proof is measured against these, not judged by taste.