Clear the foundation weep screed and vents, Home C (near Adams St), Casa Blanca, Riverside.

Mulch and decades of yard buildup have buried the stucco weep screed and foundation vents on this block's older homes, trapping moisture in the wall assembly and inviting termites through the buried wood-to-soil contact.

Where

the 3700 block of Adams St, Casa Blanca neighborhood, Riverside, CA 92504 · Open the map

Pay

$80 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash — recorded, and readable any time at vealth.net/labor/credit/(your wallet). You see which before you claim, never after.

Proof

before/after photo pairs per weep screed/vent run + clearance measurement + GPS

This is exactly what gets it approved. Nothing settles without it.

Level

entry

Open until

2026-10-17

Posted by

0x034F…6c89

The creator wallet. Its signature is what approves proof and settles the wage.

How this work is done

A documented method, so this packet comes out the same whoever does it.

Bring

• ladder rated for gutter-line access (or a ground-level gutter-cleaning wand) + gloves
• garden hose or gutter scoop + bucket for downspout flush
• exterior-grade caulk/sealant + putty knife for minor envelope-crack sealing
• flexible dryer-vent brush kit + shop vacuum for lint clearance
• camera + GPS + tape measure

Steps

1. 1. ASSESS: photograph each gutter run, downspout outlet, foundation weep screed/vent, exterior crack, and dryer-vent termination as found (debris, growth, buried screed, crack width, lint buildup).
2. 2. Clear gutters and downspouts by hand or scoop, working from a stable ladder or ground-level tool; flush each downspout with water and redirect any outlet that discharges against the foundation to daylight at least 3 ft away.
3. 3. Clear vegetation, mulch and debris from weep screeds and foundation vents so the wall assembly can drain and breathe; clean and prep any minor exterior envelope crack (non-structural, hairline to 1/4 in) and seal it with an exterior-grade sealant matched to the substrate.
4. 4. Clear the dryer-vent duct run with a flexible brush kit from both the machine end and the exterior termination, and vacuum out the accumulated lint.
5. 5. VERIFY: photograph each item from the matching before-vantage, pour a test cup of water down each cleared downspout to confirm flow, and confirm the dryer-vent damper opens and closes freely.

What counts as done

• Before photo of each buried weep screed run and foundation vent
• After photo showing 2+ inch clearance restored from the matching vantage
• Note of linear feet cleared and vent count

Proof is measured against these, not judged by taste.