Anyone can start here · Invited single-story homes near E 64th St, Tacoma, WA 98404
Clear the gutters and downspouts at an invited single-story east Tacoma home (2026-07-19)
Tacoma's fir needles and winter rains are relentless: a clogged gutter overflows down the siding, soaks the foundation, and feeds basement damp and rot. Older east side homeowners often physically cannot do this job, and it needs doing before every wet season. Standard: HUD Healthy Homes moisture control guidance; SDG 11 (Sustainable Cities and Communities). Proof: before/after gutter photos plus a free-running downspout flush Method (HUD Healthy Homes moisture control guidance; SDG 11 (Sustainable Cities and Communities).): 1. Confirm the host's invitation and walk the roofline from the ground to spot overflow stains and sag. 2. Clear gutter debris using a ground-based gutter-cleaning pole tool with a camera or mirror check. 3. Flush each downspout with a hose until water runs free at the outlet. 4. Rake collected debris into yard-waste bags and set splash blocks straight. 5. Photograph cleared gutters, running downspouts, and bagged debris, GPS-tagged and dated. Done when: before/after gutter photos plus a free-running downspout flush
How this work is done
A documented method, so this packet comes out the same whoever does it. Typically 30โ120 minutes. Method of record: Existing-home envelope + drainage maintenance (gutter/downspout clearing, weep-screed and foundation-vent clearance, minor exterior envelope-crack sealing, dryer-vent lint clearance) โ the entry-rung DIY-safe maintenance that keeps a home dry, pest-excluded and ready for the LBC Energy/Water petal work above it. DOE Weatherization Assistance Program envelope-maintenance practice + CPSC dryer-vent fire-safety guidance. SDG 11.1 (adequate, safe housing). assess->clear/patch->verify
Bring
- ladder rated for gutter-line access (or a ground-level gutter-cleaning wand) + gloves
- garden hose or gutter scoop + bucket for downspout flush
- exterior-grade caulk/sealant + putty knife for minor envelope-crack sealing
- flexible dryer-vent brush kit + shop vacuum for lint clearance
- camera + GPS + tape measure
Steps
- 1. ASSESS: photograph each gutter run, downspout outlet, foundation weep screed/vent, exterior crack, and dryer-vent termination as found (debris, growth, buried screed, crack width, lint buildup).
- 2. Clear gutters and downspouts by hand or scoop, working from a stable ladder or ground-level tool; flush each downspout with water and redirect any outlet that discharges against the foundation to daylight at least 3 ft away.
- 3. Clear vegetation, mulch and debris from weep screeds and foundation vents so the wall assembly can drain and breathe; clean and prep any minor exterior envelope crack (non-structural, hairline to 1/4 in) and seal it with an exterior-grade sealant matched to the substrate.
- 4. Clear the dryer-vent duct run with a flexible brush kit from both the machine end and the exterior termination, and vacuum out the accumulated lint.
- 5. VERIFY: photograph each item from the matching before-vantage, pour a test cup of water down each cleared downspout to confirm flow, and confirm the dryer-vent damper opens and closes freely.
If it does not match the plan
- Crack is wider than 1/4 in, stepped, or shows active movement -> STOP, do not seal, route to a licensed structural inspector.
- Gutter-line access requires a ladder above 2 stories or a steep/wet roof -> route to a licensed/insured gutter contractor instead of DIY.
- Weep screed or vent is buried under hardscape/grade that would require digging to expose -> document and route to a contractor rather than disturbing it.
What counts as done
- Before/after photo pairs for every gutter run, weep screed/vent, crack and vent termination worked
- Downspout water-flow test showing clear discharge routed away from the foundation
- Dryer-vent damper opens/closes freely after clearing, with a lint-removal photo
- No structural crack (wider than 1/4 in, stepped, or actively growing) sealed over โ those route to a licensed inspector instead
Proof is measured against these, not judged by taste.
Claiming is free. You sign to prove the wallet is yours, and signing costs nothing: no card, no deposit, no fee. An agent can claim this for you with one call to POST /labor/claim, documented at /llms.txt.
Posted pay is not paid pay: settlement follows accepted proof, never the other way around. Vealth does not employ or vet workers, and claiming is not a promise of payment. See how proof and receipts work.