Weed, clear, and mulch the tree pits along a Florence Avenue block face (2026-07-19)

The tree pits along Florence Avenue's commercial blocks are compacted and litter-filled, and the corridor is one of the hottest, least-shaded walking streets in unincorporated LA County. Restored pits keep the surviving trees growing over a street thousands of people walk to buses and shops every day. Standard: County parkway tree well maintenance practice; SDG 11 (Sustainable Cities and Communities). Proof: Before/after pit photos plus block-face photo Method (County parkway tree well maintenance practice; SDG 11 (Sustainable Cities and Communities).): 1. Count and photograph every tree pit on the assigned block face. 2. Hand-pull weeds and litter from each pit and loosen the surface crust with a hand cultivator. 3. Spread two to three inches of mulch keeping the trunk flare clear. 4. Bag litter for disposal at a legal collection point. 5. Photograph each pit after, plus the block face, with date and GPS. Done when: Before/after pit photos plus block-face photo

Where

Tree pits, Florence Ave block face near Compton Ave, Florence-Firestone, CA 90001

Pay

$200 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

Before/after pit photos plus block-face photo

This is exactly what gets it approved. Nothing settles without it.

Level

entry

Open until

2026-10-19

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 45–120 minutes. Method of record: Street-tree pit restoration per ISA arboriculture BMPs + municipal urban-forestry standards (de-compact, weed, amend, mulch, water) — hand tools only, no root cutting; assess→restore→verify

Bring

• hand cultivator/garden fork + weeding tools (hand tools only)
• arborist wood-chip mulch (3-inch layer, keep off the trunk flare)
• watering container(s) / water source access
• camera + measuring tape

Steps

1. 1. ASSESS: photograph the tree pit as found; note compaction, weeds, trash, girdling material (wire, cords, mats), soil level against the trunk flare, and visible trunk damage.
2. 2. Clear trash and weeds by hand; remove any girdling material from the trunk wherever it lifts free without cutting bark.
3. 3. De-compact the top 2–3 inches of pit soil with a hand fork WITHOUT cutting roots ≥1 inch — work around them; level soil away from the trunk flare so the flare is visible.
4. 4. Apply a 3-inch arborist-chip mulch ring keeping a 3-inch gap at the trunk (no volcano mulching), and water thoroughly (15–20 gallons for a young tree).
5. 5. VERIFY: photograph the finished pit from the matching vantage (flare visible, mulch ring correct, pit weed-free) and log the watering; flag dead/hazard limbs or trunk wounds to the municipal urban-forestry line — never prune above shoulder height yourself.

If it does not match the plan

• Roots ≥1 inch in the work zone -> work around them; never cut structural roots.
• Dead/hanging limbs, major trunk wounds, or a leaning tree -> photograph and report to urban forestry; no pruning above shoulder height, no ladder work.
• Suspected utility conflict in the pit (exposed line, meter box) -> stop digging and report.

What counts as done

• Before/after photos from matching vantage; trunk flare visible, no mulch against bark
• Pit de-compacted and weed/trash-free; girdling material removed and photographed
• Watering completed and logged (volume noted)

Proof is measured against these, not judged by taste.