Install an attic radiant barrier, home 1 -- the Palmer Avenue residential corridor, Allensworth, CA 93219.

The survey found this attic with no radiant barrier under a roof deck that bakes all summer; stapling reflective foil to the rafters, facing an open air space, cuts the radiant heat load reaching the insulation and ceiling below.

Where

the Palmer Avenue residential corridor, Allensworth, CA 93219 · Open the map

Pay

$260 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash — recorded, and readable any time at vealth.net/labor/credit/(your wallet). You see which before you claim, never after.

Proof

before/after photos + coverage-area log + fastening-spacing check + GPS

This is exactly what gets it approved. Nothing settles without it.

Level

advanced

Open until

2026-10-19

Posted by

0x034F…6c89

The creator wallet. Its signature is what approves proof and settles the wage.

How this work is done

A documented method, so this packet comes out the same whoever does it.

Bring

• tablet/clipboard
• tape measure
• light meter (lighting scope)
• clamp thermometer (refrigeration scope)
• 12-month utility bills
• camera
• ladder + spotter (high fixtures)

Steps

1. 1. Confirm the address; arrange a staff escort for mechanical/back-of-house.
2. 2. Photograph HVAC, lighting, envelope, and any in-scope systems.
3. 3. Inventory systems: HVAC type + age; lighting fixture count/type/wattage; refrigeration units; envelope condition.
4. 4. Summarize 12 months of utility use (kWh / therms) from the bills.
5. 5. Take the in-scope measurements (light levels, unit temperatures, seal condition).
6. 6. Rank no-cost/low-cost measures, then capital measures, with rough savings logic.
7. 7. Enter inventory, measurements, utility summary, photos, and the ranked measure list; sign.

What counts as done

• Before photo of the bare roof deck/rafters
• Coverage-area log matching installed square footage to the attic's roof-deck area
• Fastening-spacing photo confirming the foil is stapled to the rafters with a clear air space maintained
• After photo of the completed installation

Proof is measured against these, not judged by taste.

The standard this serves

Energy Efficiency Audit. Energy efficiency work begins with the walkthrough audit, the kind the ASHRAE standard describes: a trained eye moving through a building, reading the bills, the walls, the lights, and the equipment, and coming out with the short list of fixes worth doing first. Mastery looks like an auditor who can feel where a building is bleeding money within the hour, and prove it on paper. That instinct is trained by repetition on real buildings. This packet is one repetition: one system observed, one reading taken, one finding recorded the way the standard asks.