Retrofit missing detectable-warning domes onto a curb ramp on 6th Street, ramp 3, 6th Street & W Hidalgo Ave corridor, downtown Raymondville, TX 78580 (public right-of-way).

A curb ramp along downtown Raymondville's 6th Street corridor is structurally sound but was never fitted with the ADA PROWAG-required detectable-warning dome surface, leaving no tactile cue for a visually-impaired pedestrian at the street edge in this Rio Grande Valley county seat.

Where

6th Street & W Hidalgo Ave corridor, downtown Raymondville, TX 78580 (public right-of-way) · Open the map

Pay

$210 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash: recorded, and readable any time at vealth.net/labor/credit/(your wallet). You see which before you claim, never after.

Proof

before/after photos + dome-panel spec sheet + anchor-set photo + GPS

This is exactly what gets it approved. Nothing settles without it.

Level

advanced

Open until

2026-10-22

Posted by

0x034F…6c89

The creator wallet. Its signature is what approves proof and settles the wage.

How this work is done

A documented method, so this packet comes out the same whoever does it.

Bring

• right-of-way permit + cones/barricades + pedestrian detour signage
• smart level / digital inclinometer + tape measure
• concrete tools + detectable warning surface (truncated dome) panel per city standard
• wet-cut saw with water feed (dust control)

Steps

1. 1. ASSESS: measure the existing ramp against PROWAG R304 (running slope ≤8.3%, cross-slope ≤2%, landing, flush transition, detectable warning) and photograph each failure; confirm permit + utility locates before cutting.
2. 2. Set up cones/barricades and a safe pedestrian detour outside the work zone.
3. 3. Remove the failed ramp section with wet-cut dust controls; form and place the corrected ramp geometry per the city standard drawing.
4. 4. Set the detectable warning surface (truncated domes) aligned and embedded per spec; finish transitions flush with the gutter.
5. 5. VERIFY: re-measure every R304 dimension with the smart level, photograph readings + before/after from matching vantage, water-test the gutter flow line, and close out the permit.

What counts as done

• Before photo of the ramp with no detectable-warning surface
• Spec sheet/photo of the PROWAG-compliant detectable-warning panel used
• Photo of the panel anchored flush and level at the ramp's base
• After photo of the finished, anchored dome surface

Proof is measured against these, not judged by taste.